Orange pi plus case

Marek · Published in 2015-6-7 05:47:39

Hello

I've made a case for Orange pi plus for 3D print. This version is for multimedia device that I use with my TV. No GPIO and camera terminal holes. I'll add them in another design. Feel free to comment and give suggestions.

Design:
http://www.thingiverse.com/thing:867313

Bye !

Sergey · Published in 2015-6-12 13:37:21

It is my minimalistic instalation, thermal exchange is good because all is opened

gaara · Published in 2015-6-7 06:01:40

Good job !

garyang · Published in 2015-6-7 09:56:09

Nice job~~~
I think it needs under hole for better cooling.
Opi plus is hotter then rpi.

RaveenBouy · Published in 2015-6-7 15:30:41

Wow nicely done ^_^

cyryllo · Published in 2015-6-10 04:26:39

Thanks to Mark who sent me the 3D project boards, I will also prepare a casing with possibility to install the HDD or SSD

Sergey · Published in 2015-6-10 12:01:55

People, i try few time but not success about Lasercut case. There are many case for other SBCs made with acrylic glass. So i be glad if anybody paste there himself project lasercut case

Grampy · Published in 2015-6-10 23:06:50

I made this case down the workshop, installed a fan & heat sinks it's a lot cooler and lot stronger than the one that came with the Pi.

Sergey · Published in 2015-6-12 13:24:14

Edited by Sergey at 2015-6-12 15:17

Grampy replied at 2015-6-10 23:06
I made this case down the workshop, installed a fan & heat sinks it's a lot cooler and lot stronger ...

Could you paste here file, from wich you cut it case?

Grampy · Published in 2015-6-12 17:17:19

Hi Sergey
what format would you like it in? dxf, G code or other? I used 4mm acrylic, CNC modified hobby mill with a 2mm cutter to cut the frame out. control programme used Mach3. the fan and heat sinks came from ebay for under £3.00 GBP

regards
Grampy

Orange pi plus case

This thread contains more resources

This thread contains more resources