I finally configured embeded IR sensor on my Orange PI PC and I'm able to sleep/wake up OpenELEC it from remote control.
Unfortunately OPI case will be hidden behind screen so I need to expose IR sensor to be still visible for RC - I guess it's a common use case.
I connected common TSOP receiver (that before was working on Raspberry) to GPIO pins (I tried PA18 and PA19) and changed script.bin respectively:
ir_rx is not used anymore. I'm not sure if it ever was. The point is, HW IR support is on one pin only and that is already connected to IR sensor. You have two options, as already suggested, unsolder IR receiver and insert cables between, or put IR sensor on GPIOs and load another driver (I guess gpio-ir-recv.ko). But here you on your own. You would also lose ability to wake up board from sleep.
jernej replied at 2017-1-6 00:34
ir_rx is not used anymore. I'm not sure if it ever was. The point is, HW IR support is on one pin on ...
Thanks @jernej, @cbm80 and you are right - de-soldering was the best solution (already did it).
I spent some time and found much more complicated solution here http://www.orangepi.org/orangepi ... amp;fromuid=1185139
It seems that using GPIO IR receiver is not such simple like on RPI.
It is my first visit to your blog, and I am very impressed with the articles that you serve. Give adequate knowledge for me. Thank you for sharing useful material. I will be back for the more great post. what is myip
Any movies is normally outstanding. You've gotten a lot of particularly as good writers and singers. Document prefer you will the best quality about financial success. Iptv
Many thanks for that publish as well as excellent ideas.. actually We additionally believe that effort is actually the most crucial ingredient of obtaining achievement. iptv smarters pro