|  | 
 
| Hello, just inastalled the Archlinux_minimal.img from 19.10.2015 via mega.nz
 After installation I was able to log into my OrangePi PC using the serial console. The vertical USB does'nt work, the two horizontal do. (was able to mount a USB drive).
 Tried to activate the ethernet interface, but failed:
 
 Both leds on the ethernet link are on permanently. No blinking - no reaction. I guess some hardware setting is missing ?!
 On a different image (slackware) I have seen, that the LEDs are not permanently on and blink according to the network traffic.
 I did:
 >>>>systemctl -l status systemd-networkd.service<<<<
 * systemd-networkd.service - Network Service
 Loaded: loaded (/usr/lib/systemd/system/systemd-networkd.service; enabled; vendor preset: enabled)
 Active: active (running) since Mon 2015-10-19 14:11:11 UTC; 1h 15min ago
 Docs: man:systemd-networkd.service(8)
 Main PID: 239 (systemd-network)
 Status: "Processing requests..."
 CGroup: /system.slice/systemd-networkd.service
 `-239 /usr/lib/systemd/systemd-networkd
 
 Oct 19 14:11:10 OrangePi systemd[1]: Starting Network Service...
 Oct 19 14:11:10 OrangePi systemd-networkd[239]: Enumeration completed
 Oct 19 14:11:10 OrangePi systemd-networkd[239]: eth0: eth0            : could not bring up interface: Operation not supported
 Oct 19 14:11:11 OrangePi systemd[1]: Started Network Service.
 Oct 19 14:11:11 OrangePi systemd-networkd[239]: eth0: Removing non-existent address: fe80::ad93:ef4e:c6f6:b5c6/64 (valid for ever)
 
 >>>>ip link set eth0 up<<<<  - comes back without message, but afterwards eth0 is still down:
 >>>>ip link show eth0<<<<
 2: eth0: <BROADCAST,MULTICAST,DYNAMIC> mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000
 link/ether e6:7e:31:74:18:ed brd ff:ff:ff:ff:ff:ff
 
 Has somebody an idea what to do to get the ethernet running ?
 
 Regards medeiros
 
 | 
 |