View: 4533|Reply: 4

No Power, No Booting

[Copy link]

2

threads

2

posts

10

credits

Novice

Rank: 1

credits
10
Published in 2017-11-13 00:05:41 | Show all floors |Read mode
I orderd 2 OP PC2, but No LED is flashing if I power them on. An older OP works. 5V/3A Supply..

62

threads

653

posts

5498

credits

Administrator

Rank: 9Rank: 9Rank: 9

credits
5498
Published in 2017-11-13 13:50:43 | Show all floors
Did you check  your SD card and the image you wrote? Did you try another image for PC2? Same result?

0

threads

24

posts

170

credits

Registered member

Rank: 2

credits
170
Published in 2017-11-14 14:36:53 | Show all floors
[size=17.1429px]he Ethernet and power LED wont light if the board dont boot, so most people will consider it dead. Acutally it just dont boot.
[size=17.1429px]So download images on Orangepi offical web for PC2, and burn it to the 8 or 16 GB 10class SD card.

[size=17.1429px]Power the PC2 from the DCIN port

3

threads

159

posts

110K

credits

Forum patriarch

Rank: 8Rank: 8

credits
12028
Published in 2017-11-18 22:24:33 | Show all floors
Edited by Tina at 2017-11-18 22:45

Hi,
Which image do you use and what power supply (eg. official, phone, generic from aliexpres,...) have you there?

Please check 1. the voltage at the 5V rail: GPIO pin 2 or 4 (5V) and pin 6 (GND). Many power supplies do not hold a stable voltage above 5V with a load and the Orange Pi's need a stable 5+ voltage. It could be that your power supply just drops a little bit under 5V, but enough to power the old OP and the OP PC2 needs just a bit more power.

If this is OK, check the image on the µSD card. In the past with my first attempts i had problems if I did not follow closely the instructions of each ROM.

I have no problems with armbian and you find the images here
Please click on reply when answering direct to me. That way I get a notification ;)

"Those who would give up essential liberty to purchase a little temporary safety deserve neither liberty nor safety."
                                  Benjamin Franklin 1755

0

threads

2

posts

8

credits

Novice

Rank: 1

credits
8
Published in 2018-1-4 04:53:21 | Show all floors

If the OPi does not have a memory with an operating system installed does not work, does not turn on, uses a class 10 memory for better results, test downloading the image of some operating system, Retrorangepi for example installs the image using "Etcher" to me it worked .
You need to log in before you can reply login | Register

Points Rule

Quick reply Top Return list