OrangePi 2g-IOT putty garbage info

raimundo151179 · Published in 2017-5-15 11:20:16

Hello, I have some problems with the linux disto, I tried ubuntu, debian and raspbian images and the only information that I can see on putty console is like the image attached and the the boot is halted, the booting is not working.

do you have why this is happening?

tpickle · Published in 2017-5-19 07:41:48

A couple reasons you can get that, one is wrong baud rate, two noise on the tx line on device, three wrong com port. Most likly its #1. Can you provide your settings? Also what jumper setting is your 2G-IOT on?

raimundo151179 · Published in 2017-5-20 02:49:04

I found the error, I have to install and configure all again. Thanks.

antimatter · Published in 2017-6-8 15:36:00

Could you please share to solution? What was the problem? I've the same issue.

manishpandey · Published in 2017-6-12 01:51:57

Edited by manishpandey at 2017-6-12 03:04

Please share the solution. I tried using 115200 & 921600 baud rate & jumper setting as its shown in documentation. I have tried with sandisk 8gb class 4 & sandisk 16gb class 10. both gave garbage value on console.

nopnop2002 · Published in 2017-6-12 21:34:31

Edited by nopnop2002 at 2017-6-12 21:49

manishpandey replied at 2017-6-12 01:51
Please share the solution. I tried using 115200 & 921600 baud rate & jumper setting as its shown in ...

I used TeraTerm & SanDisk Ultra 8GB.
https://ttssh2.osdn.jp/index.html.en

BaudRate is 921600.

I succeeded in installation.

OrangePi 2g-IOT putty garbage info

This thread contains more resources

This thread contains more resources