[SOLVED] IR remote no response

oppai · Published in 2016-6-3 19:51:09

Edited by jernej at 2016-6-3 17:45

there are two kind of good and bad images for IR remote
I tested
I know there are files SYSTEM and KERNEL
when opi doesn't work IR
I only change bad KERNEL with good KERNEL
It works good
I compare dmesg

good
>rc0: sunxi-ir as /devices/virtual/rc/rc0
>rc rc0: lirc_dev: driver ir-lirc-codec (sunxi-ir) registered at minor = 0
bad
<rc0: sunxi-ir as /devices/platform/sunxi-ir.0/rc/rc0
<rc rc0: lirc_dev: driver ir-lirc-codec (sunxi-ir) registered at minor = 0
<sunxi-ir s_cir0: initialized sunXi IR driver

so then
I find [s_cir0][cir] section in fex file
they have ir_used parameter
but that is not efficient at all
I think so

any suggestion?

Dima · Published in 2016-6-3 20:49:36

I don't understand what are you trying to do? IR works just fine in the normal image. Check the FAQ on how to use ;-)

jernej · Published in 2016-6-3 21:41:07

On top of that, mixing kernel and system files is not a good idea and not supported.

oppai · Published in 2016-6-3 22:29:38

dear jernej
I have used image
tvout thread's
http://www.orangepi.org/orangepi ... &fromuid=850407
It's good image
bad KERNEL is compiled by jernej(sorry bad expression)
I only need fsmoke's kernel config?
do you know the difference ?

jernej · Published in 2016-6-3 22:54:33

TV out is supported in latest and previous image. You just have to enable it in script.bin which is all explained in FAQ thread. There is also explained how to set up IR sensor. IR values in script.bin are ignored.

oppai · Published in 2016-6-4 00:29:43

[solved]
ok I can enable tvout and IR sensor
only I should have erased line "lircd /storage/.config/lircd.conf" in autostart.sh
It works well
my fault and thanks