|
|
This post was finally edited by sergiomarina at 2023-10-17 04:18
This post was finally edited by sergiomarina at 2023-10-17 04:17
This post was finally edited by sergiomarina at 2023-10-17 04:09
Hi,
the board's boot hangs up and here below the last lines got from the serial interface
....
....
[ 3.717122] Kernel panic - not syncing: Oops: Fatal exception in interrupt
[ 3.723997] SMP: stopping secondary CPUs
[ 4.835875] SMP: failed to stop secondary CPUs 0,2
[ 4.840672] Kernel Offset: disabled
[ 4.844161] CPU features: 0x00000,00800080,0000420b
[ 4.849041] Memory Limit: none
[ 4.852104] ---[ end Kernel panic - not syncing: Oops: Fatal exception in interrupt ]---
Is there a way to fix this panic?
Thanks a lot for suggestions.
note: if I switch the SD card to an other OPi PC2 (same version v1.1), it boots flawlessly.
|
|
Show IP Card
Radar Card
Published in 2023-10-17 03:42:57
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post