Openelec Build for OPI PC and 2 now with HW decoding

caracolo · Published in 2016-9-25 05:10:41

The mouse doesnt work, what can I do? Thanks

jernej · Published in 2016-9-26 03:32:17

caracolo replied at 2016-9-24 22:10
The mouse doesnt work, what can I do? Thanks

check if you installed correct image?

giaur500 · Published in 2016-9-26 17:06:17

For me, mouse sometimes stops working, just like that. Especially when not used long time. I need to reboot to make it working again. Remote works fine.

jernej · Published in 2016-9-27 01:33:22

giaur500 replied at 2016-9-26 10:06
For me, mouse sometimes stops working, just like that. Especially when not used long time. I need to ...

dmesg output would be welcomed next time this happens to you...

jernej · Published in 2016-9-27 02:23:02

This test image https://transfer.sh/sJeGH/openel ... r23093-gead6f5b.tar (available for 14 days) has libcec improvements among others. One of the fixes should fix waking TV, can someone test this?

andrzejm · Published in 2016-9-27 07:29:31

I've tested on image built today based on latest SW and yes, TV 42LM615S woke up after starting Orange Pi

hav · Published in 2016-9-29 15:35:53

I've tested, work fine. Opipc.

andrejb · Published in 2016-10-1 01:37:36

nice, i successfully compiled the source again (git clone from scratch) and it is building OK again (since may 2016 or something it was failing). looks like the patches for new software is working

jernej · Published in 2016-10-1 01:52:22

Edited by jernej at 2016-9-30 18:59

andrejb replied at 2016-9-30 18:37
nice, i successfully compiled the source again (git clone from scratch) and it is building OK again ...

Idea is that it is always possile

But I may miss an issue because all sources are cached on disk and I deleted them just once or twice... Just report such things

While you are at it, could you test patches I commited just a minute ago? I'm interested if you notice any speed improvement like boot time or GUI responsiveness etc. Do you think those times are improved comparing to August binaries?

andrejb · Published in 2016-10-1 03:27:34

i reported the problem...

it failed in

image: creating partition table...
image: creating part1...
image: creating part2...

Copy code

part.

anyway.. i compiled again and installed:
1. i can not tell the difference in boot - i do not boot often, but i have it always on (i do sometimes experience (lets say 1 in 5 times) that cec does not wake up opipc (when i start the tv and receiver and switch to opipc) and than a reboot is needed to get the cec back working)
2. the ui i guess is now more responsive (according to 5 minutes usage)