giaur500 replied at 2016-8-2 09:58
Jernej, any chance for proper vsync for interlaced videos with new libreElec you are going to switch ...
This will bring newer version of Kodi (which works already, but only SW decoding) and along an improved video playback engine. I will try to write HW support from scratch and we will see how deinterlacing will work out.
tom123 replied at 2016-8-3 09:39
Hello,
probably yes. There is link of RPi mod http://engineering-diy.blogspot.si/2013/11/control-x ...
You have multiple options here. Safest would be to use OpenELEC build system to compile this project. You would need to create at least two packages, one for WiringPi and another for source you referenced. Another, more risky, but simpler, would be to compile WiringPi and your source on general purpose distribution like Armbian and then copy WiringPi lib and executable to OpenELEC. Possible problem here is that libraries on both system are not compatible, but the risk is very low. Even if succed, I'm not sure how FM module fits the picture (referenced in code). Can you just ignore it? Good luck!
jernej replied at 2016-8-4 02:45
Ok, I think I finally nailed that crash during channel switch, thanks to Joog. Can anyone try this u ...
Thank you, good work, channels(IPTV,multicast,sd+hd) do not crashing, but on some channel switching have 0,3sec artefact (green stripe), both crashing before this update and slow(3sec) switching, may be add speed switching?
How to make the Power_On from the IR remote? add code to script.bin?
Yep, Jernej, it works!! Thanks! Nice job!
But with this update i must forcibly to disable vsync (already do that before), in other way HDMI-CEC is switching off after first remote click))) I just power-off/on my tv and it works again, but only first press on my remote. Thats not critical for me, just bugreporting here...
c0013r replied at 2016-8-4 17:24
Thank you, good work, channels(IPTV,multicast,sd+hd) do not crashing, but on some channel switchin ...
Sorry, I don't understand what do you mean. Do you feel that somethimes it needs to much time to switch? Currently I have others thing to do...
IR power on (after you put it to sleep with remote or power key) may or may not work already. You definetly need NEC IR remote for that. Check/set IR keys in script.bin in [s_cir0] section. From what I understand, you should set at least one ir_power_key_code/ir_addr_code pair to your remote key. After that you should be able (not tested) to wake up your box with set keys. Please report your (un)success
where can I get ir_power_key_code/ir_addr_code ? i have NEC, in lircd.conf "KEY_POWER 0x807F "
"ir_addr_code0 = 0x807F" yes?
"ir_power_key_code0 = ???"
[Copy link]
Show IP Card
Radar Card
Published in 2016-8-2 16:58:43
Anonimous Post
Published in 2016-8-3 04:29:10
