How to access the GPIO Pin on Orange pi Zero 2+?

josephjo · Published in 2021-5-19 02:34:51

I trying to connect my APM flight controller to the GPIO pin 8 and pin 10 of Pi zero 2+ h3

I did it on Raspberry only by setting up the serial on raspi-config.

I am using armbian anyone knows how can I do the same?

charlly · Published in 2021-6-17 00:28:00

I am new to this forum so I do not know much about the orange Pi forum. I hope through the other member's posts from this forum buy Rémy Martin I can get more information regarding it. Do have a look at it.

josephjo · Published in 2021-6-17 07:10:53

charlly replied at 2021-6-17 00:28
I am new to this forum so I do not know much about the orange Pi forum. I hope through the other mem ...

Are you posting right? The link is incorrect

megauti · Published in 2021-6-22 12:08:04

Edited by megauti at 2021-6-22 12:54

I believe you can do same on armbian-config. It is what raspi-config is for armbain.
For full-level of GPIO control for Zero 2 in Python, check out this library.
https://github.com/eutim/OPI.GPIO
Other version does not support the Orange Pi Zero 2 board.
Also, armbian is not ready for Zero 2 yet. I have noticed many GPIO functions yet ready.
My recommendation is that try debian desktop version for now.