Orange Pi One Ethernet LEDs on but the board does not work

Kian · Published in 2018-2-22 23:25:15

Hello

I got this board and i'm using a 5 V, 2 amps , power supply with SD card 10! but the system does not boot up

Any suggestion? thanks

Tina · Published in 2018-2-23 14:50:24

Hi,
There are 2 possible cases here:

Your power supply is not able to hold stable 5V, many power supplies are rated 5VxA but drop the voltage below 5V. This causes the OPI to stop at the boot process. To check if your PSU holds stable 5V, please use a Multimeter. Connect it to GPIO pins 2 or 4 (5V) and pin 6 (GND). If the voltage stays above 5V the PSU is good.
The image µSD card is not written correctly. Please follow the instructions of the makers of the image. Also have in mind that most images on the Xunlong/OrangePI pages are outdated. I use armbian and RetrOrangePI images from their web pages on my OPI and have no problems so far.

Kian · Published in 2018-2-23 20:42:15

Edited by Kian at 2018-2-23 20:59

I've checked the voltage , it's around 5.1V! then the problem must be the SD card

Tina · Published in 2018-2-24 16:05:49

Okay,
If you use Android, there are reports of other users (I use armbian) that there are problems with the pheonix flash tool. Please have a search in the forum.
If you use armbian, please download it from their side (link) and follow their instructions (link).

I hope that helps ;)

xyzzsdfl · Published in 2022-4-14 04:34:34

It's a very good guide, Bless you designed for issuing all of us this post. Continue advertisment. Packers and Movers in Kolkata

Orange Pi One Ethernet LEDs on but the board does not work

This thread contains more resources