Working with RGB LED matrix

Otani · Published in 2016-1-17 16:50:08

Edited by Otani at 2016-1-17 18:12

Hi all. Someone working with RGB LED matrix by Adaftuit? I tried to connect matrix as shown on tutorial for Raspberry Pi and using their code, but all atemps were failed. Help me, please.
Links:
Matrix page
Tutorial

P.S I'm using Orange PI 2 (H3)

Otani · Published in 2016-1-23 17:14:44

Thx all. This is ONE OF THE BAD COMMUNITY OF ALL SBC IN THE WORLD.

NO HELP

Giachi · Published in 2016-1-17 19:52:44

Did you read this http://www.orangepi.org/Docs/WiringPi.html ?

Otani · Published in 2016-1-17 22:48:03

Yes, but link on this page isn't working.

phreon · Published in 2016-1-17 23:51:15

Take a look at this thread:
http://www.orangepi.org/orangepi ... &extra=page%3D1

Otani · Published in 2016-1-18 14:20:50

So, is it not possible?

matsumo · Published in 2016-1-23 17:39:12

Otani replied at 2016-1-23 17:14
Thx all. This is ONE OF THE BAD COMMUNITY OF ALL SBC IN THE WORLD.
NO HELP

while it is true that software support on the orange pi is not the absolute best, and pretty much all of us are just experimenting to trying to get things to work. i am guessing this was not the product for you at this moment, and that is too bad. having said that, i think it is a bit unfair to say this is the worst community in the world..

matsumo · Published in 2016-1-23 17:40:11

Otani replied at 2016-1-23 17:14
Thx all. This is ONE OF THE BAD COMMUNITY OF ALL SBC IN THE WORLD.
NO HELP

i mean, you have not even told us, what you have tried...not showed any code...not given people much to go on, you know?

Otani · Published in 2016-1-23 18:10:14

I tried to connect matrix to pins as in manual and used code from example. No result.

WereCatf · Published in 2016-1-23 18:28:58

If you are going by the Adafruit - tutorial the pins will not have the same GPIO-numbers associated with them as they are on the RPi and you have to modify the code accordingly.