Hi everyone! I recently purchased an Orange Pi WinPlus A64 and am trying to connect it to a Waveshare 10.1-inch HDMI touch panel using the 26 GPIO pins. I've enabled the SPI interface and followed the relevant tutorials, but the display says 'No Signal.' Has anyone experienced this issue before, or can anyone guide me on the correct configuration or additional steps I may need to take? Any help would be greatly appreciated!
Show IP Card
Radar Card
Published in 2023-8-8 17:50:47
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post