|
This post was finally edited by mkgokp7s at 2022-11-23 17:39
Does anybood succeed in using the SPI interface on the GPIO pins?
I found some devices on /sys/bus/spi/devices/ named spi0.0 (the rda-dpi-panel) and spi0.1 (the tlv320aic23-spi).
Also the kernel.log shows spi when booting, so in general SPI seems to be enabled in the kernel.
The way the Raspberry Pi is enabling SPI via dtoverlay and dtparm seems not to work with the older 3.10 kernel.
How to make SPI usable for devices connected via GPIO?
Thanks
Achim
|
|