Working with RGB LED matrix

Otani · Published in 2016-1-24 04:39:22

So what I must correct ?

WereCatf · Published in 2016-1-24 12:09:40

I don't have an RGB LED-matrix or even an Orange Pi to test with, so your best bet is to hope someone else here can help you.

Otani · Published in 2016-1-24 21:52:43

As I have understood, this is main difference:
https://github.com/hzeller/rpi-r ... /master/lib/gpio.cc

which addresses similar registers ?

Dermenslof · Published in 2016-1-25 02:36:16

Edited by Dermenslof at 2016-1-25 02:43

verify your mapping pins gpio with :
$> gpio readall
PS: need install WiringOP

Otani · Published in 2016-1-26 02:21:20

It's working fine

Otani · Published in 2016-1-27 14:15:36

Dermenslof replied at 2016-1-25 02:36
verify your mapping pins gpio with :
$> gpio readall
PS: need install WiringOP

And? What next step?

mix007 · Published in 2016-6-7 01:43:18

Hi ! I have the same problem.
Is there any progress with the LED matrix? I think what need to start with a file framebuffer-internal.h There are described used GPIO

nopnop2002 · Published in 2016-6-7 07:16:55

Edited by nopnop2002 at 2016-6-7 19:40

rpi-rgb-led-matrix doesn't use WiringPi.
Address of GPIO operation is being done by itself.
Substantial correction is needed.

If you rewrite this cord, it may work only a little.

https://github.com/hzeller/rpi-r ... /master/lib/gpio.cc

Because they seem to use hardware PWM.
GPIO of H3 board doesn't have the hardware PWM function.