.config file for orange pi 2g iot android kernel

vikranth_g

Hi All,

I downloaded both NAND and SD Card Android image for Orange Pi 2G IOT
Also downloaded android source and followed the steps are per user manual to compile android source
I tried to insmod usbserial.ko that is part of the stock image (both NAND and SD Card), it gets loaded properly
But when I try to insmod the usbserial.ko that is generated when I build android source, it fails with mismatching symbol versions
Compared the symbol version, they are as below (for simplicity mentioned only two symbols)

Symbol	Stock Nand Image	Stock SD Card  Image	Built Nand	Built SD Card
module_layout	0x54803bd1	0xc6d2c755	0x27325e60	0x27325e60
tty_port_tty_get	0x64b5d17f	0x21a53703	0x13af3e71	0x13af3e71

This shows that the config options that were used to build Stock Nand, SD Card android image are different from the sources uploaded.
Can you please provide the config options that were used for building the stock NAND and SDCard android images for Orange Pi 2G IOT

Thanks,
Vikranth