Hey guys! I am new to orange pi myself I have a pc and a zero...pc is working flawlessly but with my zero I get a signal to the tv through the a/v out to rca but the picture is terrible its black and white and very fuzzy do you know what I am doing wrong? I have about 4-5 different cables of the same type to hook it up and still the same problems yet only one of them works. Please let me know thank you! PS yes does over-scan as well.
So, on which pin did you plug the cable to get the video, and where did you get it?
I was thinking on getting the extension board, but it is still a mystery to display something on a VGA monitor...
gounthar replied at 2018-5-9 00:38
So, on which pin did you plug the cable to get the video, and where did you get it?
I was thinking o ...
If would be better for you to refer to the schematic. Since as information i have, if connecting from the pin to have output directly, it may not work. Maybe there would be still need a converter board. So sorry i have not test this before.
I just found this blog and have high hopes for it to continue. Keep up the great work, its hard to find good ones. I have added to my favorites. Thank You. Press Release for Entrepreneurs in USA
Show IP Card
Radar Card
Published in 2017-12-30 10:34:56
Anonimous Post
Published in 2018-5-9 11:34:18
