how to fix a burned orangepi one

max551 · Published in 2021-1-11 04:03:23

Hi guys.
i did a stupid move by powering my usb hub pluged on orangepi with my dc adapter set to 9v insted of 5v XD.
it is not working anymore.(armdian buster)
i have green d7 on, and both rj45ligth on.

i check some of the compenemt but found nothing.
do you know a way to troubleshoot it? can i monitor boot with tx rx pin or other way?

max551 · Published in 2021-1-11 21:17:27

http://linux-sunxi.org/images/7/7e/ORANGE_PI-ONE-V1_1.pdf

max551 · Published in 2021-1-11 22:29:41

after serial communication i found that boot stop at the begining

U-Boot SPL 2020.10-armbian (Jan 05 2021 - 02:13:45 +0100)
DRAM:

Copy code

hal8000b · Published in 2021-1-17 20:37:17

I think it may be damaged beyond repair, but power off and leave it a few hours
to make absolutely sure no residual charge exists.

If you can check your sd card in another linux system run a filesystem check to make
sure card is ok.

On my Orange Pi zero with no card and power applied I get ethernet LEDS lit and no green
power light. With a bootable sd card the green power light comes on after 2 or 3 seconds and loads normally.

I think though this is perhaps damaged beyond repair.