Adding one more USB-port

mkgokp7s · Published in 2020-4-10 05:40:33

Edited by mkgokp7s at 2020-4-10 05:44

Hi,
I would like to add one more USB-Port to my Orange Pi via the GPIO 40-pol connector. The idea is to put the OrPi on a kind of breakout board (like a HAT) where all connectiviry is accessible, like Ethernet, RS485, 1-Wire and all the interfaces I need. So the OrPi board will be completly covered inside a case.

Is there a way to add an USB port via SPI, I²C, UART or any other pin of the GPIO connector?(UART would be the opposite direction as the CP2102 chip)

thanks
Achim

mkgokp7s · Published in 2021-1-13 04:59:42

bump
-
nobody an idea here???