IOT 2G debug swithes

noffe

Hello every one
1-can some one provide me the debug specifications??
it seems its de activate USB port
2-Does battery connection charge also

3- Need AT commands datasheet of GSM module, I cannot succed with AT+CIPSTART command
Regrds

admin

1. I am not really understand what you mean about debug specifications. Maybe you need to check the usermanual at the section of Using Debug tools on OrangePi. I am not really understand what you mean about debug specifications.
2. If you want to boot the board via battery, make sure the voltage of battery is 3.7V.
3. Sorry i do not have recommendation solution except use rmanual.

noffe

Thanks for your guidlines, let me give precisions

1- What is the significance of debug dip switches port pin 1,2,3,4,5,6,7,8, i notice that some status enable usb port power for a peripheral device.
Were can i find a complete definition of those pins switches(NOT FOUND IN USER MANUAL)
2-I am OK with a 3.7 V battery, the question is does battery  REFILL when device is powered on the usb 5v OTG.??.
3- The user manual dont give AT& command SET of the gsm modem, I dont want PPP dial up connection but gprs AT+CIPSTART connectivity, but i tried without success reply +CME ERROR 58, i need datasheet.
Regards