|
|
I want to wake up my orange pi plus 2e device through the pin. It will feature a PIR sensor on this pin.
I did research in the forum, but I could not find any documents. We can wake up by applying a cutter like Arduino through a pin. How do I follow a path for this device?
When I take the device to sleep, I can not wake it up again. The buttons on it do not function at all.
|
|
Show IP Card
Radar Card
Published in 2018-3-17 05:00:49
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post
Author