OPi 2G IoT - Remote Access Configuration

LucasBSC

Hi everyone,

For the ones who have already established a 2G connection, I am trying now to access it remotely from my laptop. Does anyone here have a directional how to access the OPi 2g IoT remotely?

I am using the Ubuntu distro, my 2G connection is pretty stable but I would like to access it from my laptop that is connected on my home's Wi-Fi. Here is my 'ifconfig':

ppp0      Link encapoint-to-Point Protocol
             inet addr:10.85.98.202  P-t-P:192.200.1.21  Mask:255.255.255.255
            UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:472  Metric:1
            RX packets:6 errors:1 dropped:0 overruns:0 frame:0
            TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
            collisions:0 txqueuelen:3
            RX bytes:240 (240.0 B)  TX bytes:213 (213.0 B)



Thanks!

admin

If you have already refer to the user manual, but still shown up like this, then maybe you could try it again. The user manual should have described in detail.

secosek502

I do agree with all of the ideas you’ve presented in your post. They’re very convincing and will certainly work. Still, the posts are very short for starters. Could you please extend them a bit from next time? Thanks for the post.        Packers and Movers Chandigarh to Kurnool

Arhum54

Determine how you want to remotely access your OPi 2G IoT device. Common methods include SSH (Secure Shell) for command-line access and VNC (Virtual Network Computing) for graphical desktop access.

Enable SSH or VNC on Your Device: If SSH or VNC is not already enabled on your OPi 2G IoT device, you'll need to enable it. This can usually be done through the device's settings or configuration interface best escape rooms london. For example, you might need to enable SSH or VNC in the device's system preferences or network settings.