Orange PI Zero. USB from 13 aux pins
Hi, some days ago I got a OPI Zero and it works really great, anyway I have some questions and I hope you can give me some help.The board has 13 pins for the expansion board and (watching the map of those pins) I took a phone charger with the end of the cable broken, after a little fixing... Can I power my OPI Zero directly to the pins (5V and ground) without any resistence or fuse? I dont want burn the circuit but I guess I can. Somebody knows if really can I do it without any risk?
Another question is... Those pins has support for 2 USB ports (or this is what I understood). Same as before, can I connect directly any USB connector to the respective pins without any risk? I mean 5V, GND, DM and DP for data transfer and connect i.e. more than one USB flash to the OPI.
My last question is about the OTG. Can i enable it for an adapter and get one more USB interface?
My idea is not use all that USB at same time but i wanna know what USB ports can be useful for devices.
If you want to know, Iv'e been working with armbian for OPI Zero.
Thanks.
Well, i've got no answer about my question then i did it directly. Based on the graphic I plugged an USB female port each wire in the respective place (5V, GND, D- and D+) and it worked :D.
It has been working flawless without resistors or any other thing else. About the USB-OTG is still without work for plug whatever I want. I hope solve this topic or if someone has the answer it wouldbe usefull enriq replied at 2018-2-7 05:29
Well, i've got no answer about my question then i did it directly. Based on the graphic I plugged an ...
So sorry there is no reply or support for you but really good you have already got the answer.
Good job!
enriq replied at 2018-2-7 05:29
Well, i've got no answer about my question then i did it directly. Based on the graphic I plugged an ...
A friend is great that you found a solution. Please tell me the numbers of these contacts
You can look at the schematics of the expansion board. There is really not much in there, other than the connectors so soldering a USB connector there is totally fine. If you want protection you can add a TVS. I pluged the usb ttl cable to my orange pi zero, 4 wires, gnd, rx, tx and vcc (5v) and it work without problens. without any other power supply. My small provision shop was empty because of inflation, and I couldn't afford to restock. Customers were leaving. I took a risk and played on https://chickenroad.com.ng to raise capital. I hit a mega win that allowed me to fill my shop with goods and even buy a deep freezer to sell cold drinks, reviving my business and bringing all my customers back today Spot lets start on this write-up, I honestly think this website needs much more consideration. I’ll oftimes be once more you just read a lot more, thank you for that info. https://tr88net.com/
You’ve made many good items there. Used to do research online for the make a difference and found many people goes as well as with your blog site. https://kp88net.com/
Aw, this is a really good post. In thought I have to put in place writing in this way moreover – spending time and actual effort to create a top notch article… but exactly what do I say… I procrastinate alot and by no means apparently get something done. https://betbdt1.net/